Starter key connection.-

Dear gentlemen of the forum.-

In a 2000 Hyundai Atos, I would like to connect an “Pirulo” alarm from which I only have one drawing.
The problem is that I have to connect a (relay) relay (leg 87a) to the “start” cable of the starter and leg to + (positive of the coil) .-
Someone would know how to identify them? .-
1 celestial: it becomes + posit. 12 volt. When I turn the key to the action ACC.-
2 ??????
3 Can it be the one who goes to the coil? It is permanent negative- 12 volt.-

4

black with celestial + permanent positive 12 volt.-
5 black with yellow ?????? .-
6 celest with red ?????? imageshack.us/a/img153/3986/llavearranque667chica.jpg

cordial greetings.-

So I see the white alarm wire must have positibo of (1) contact. When you put feeding contact the alarm and relief in (85)+.
when the alarm is on - al (86).
and lets go from 30 to 87a.

In the contact key I will put you in a cable (15), if you do not put it you need to go to the coil and follow the cable a little short and put your relay cables 30 and 87a in this way when the alarm is current passes from 30 to 87a if this OFF does not pass current to the coil.

Dear Igryo
thank you very much for your attention.-
On Saturday I will proceed to put into practice your expressed comments, and then I will comment on the forum the results obtained.-
Cordial greetings.-

Dear friends of the forum.-
I fulfill the result of the alarm installation.
Works perfect.-
If someone reads this post. That he sends me a message and I will gladly help it and if necessary, I disassemble and take pictures, although it will not be necessary because I now learned the concept, so that everything is easier.-
I attach a video that was helpful:

Although the identification of the cables, for coil and for starting was my most complex problem.-
Repeated thanks and cordial greetings.-