Search in MDM

Bulletin

Problem with Jeep Cherokee 2008.

  • Manual-Mecanica
  • Author of the subject
  • Offline
  • Fresh Boarder
  • Fresh Boarder
Further
15 years 2 weeks before #14132 by manual-mecanica
Problem with Jeep Cherokee 2008. Published by Manual-Mecanica
Hello good afternoon, the problem was that traveling was turned on the battery signal, then the temperature rose to the maximum and all the sensors to turn on and turn off the temperature decreased, the car was still overheated and the water pump was burst, I had to keep driving around 15 km because it was night and traveled with children by solitary route, until a safe place where I was treated by a crane. The water pump and the battery already changed the vehicle and not heard any noise, until it reached the heating and when accelerating a little a pounding noise is heard, in addition an engine sensor continues to turn on.
The oil lost viscosity, I imagine due to overheating. If you can give me any track, I would appreciate

Please connect or create account to join the conversation.

  • Manual-Mecanica
  • Author of the subject
  • Offline
  • Fresh Boarder
  • Fresh Boarder
Further
15 years 2 weeks before #14141 by manual-mecanica
Manual-Mecanica Response on the Re: Problem with Jeep Cherokee 2008.
Hello look, I think that you are very careful with that to start, I suggest that you check the engine carefully because if you heated the engine much as probable as the packaging of the cabsas were broken and aomejor is passing water to the Czech oil if your oil does not have water or if your car does not take water through the escape or a lot of bath

Please connect or create account to join the conversation.

  • Manual-Mecanica
  • Author of the subject
  • Offline
  • Fresh Boarder
  • Fresh Boarder
Further
15 years 2 weeks before #14158 by manual-mecanica
Manual-Mecanica Response on the Re: Problem with Jeep Cherokee 2008.
Look, I believe what you say, that the noise that appears is from some taqui that is downloaded or bad lubrication, this devised to the viscocity of the oil, the first thing you should do in this type of case is to change the oil and walk it to see if everything improves, the check set on the safe with a Scaner and do not spend more, I think it only lasts to you that you do you.

Please connect or create account to join the conversation.