Fucking crap, it does not come out

The measure of axial metals would be those that corresponded to the rectified, sometimes the connecting rods and benches are rectified, but not axials

The information that I have to be 0.25 before the rectified was 0.50, now in the rectifier they told him that the axials followed at 0.25, so only change connecting rod metals and bench. And where it is locked it is just where the axials go since by the ends when moving there is slack. Try to move the bench metals and they are light, it is only the center but more tight (there is my God Lord) tomorrow I will try to apply their knowledge delivered.

Look, a advice draws the axials hitting them at one end with something that calms if they are stuck will cost a little but you can

Thanks Hector and Kikemec for your help.
Finally I managed to get it after several surrendered, thanks to the ingenuity and a hydraulic cat hahaha salt, exactly the axials had left badly and they squeezed. It is a very happy day hahaha also that here in Frutillar Amarnecio snowing.

Friend I was reading your problem I recommend that you verify the crankshaft again since having pressed him with a hydraulic cat you could have crooked it ,,, Juan I will surely live many years.