Ok I read you yesterday but the Internet left the manual that I got from the driver, I scanned it with the actr CP 9185 which gave me communication error then revised all the fuses and nothing was checked Light I do not know if this vehicle brings any module or will be the immov that is my dilemma, take the ECU to review it on Tuesday or tell me if it is bad but it is almost the immov because with that bridge it turns on tries to translate the manual but I do not understand it well here this
passlock
your vehicle is equipment with the passLock
Theft-deterren System.
Passlock is a passive theft-deterrent system. Passlock enables fuel if the ignition lock cylinder is Turned with a Valid Key. If a correct key is not used or the ignition lock cylinder is tampered with, fuel is disable.
During Normal Operation, The Security Light Will Go off approximately five seconds after the key is Turned to the run ignition position.
If the Engine Stalls and the Security Light Flashes, Wait about 10 minutes unni the light stop flashing Before Trying to Restart the Engine. Remember to Release The Key from The Start As Soon the Engine Starts.
If the Engine Does Not Start After Three (3) Tries, The Vehicle Needs Servise.
If the Engine is running and the security light comes on, you will be uble to substart the engine if you turn the Engine Off. However, You PassLocksystem is not working properly and must be Serviced by Your Dealer. Your vehicle is not protect by passLock at This Time.you May Also Want To Check The Fuse (see “Fuses and Circuit Breakers” in the Index). See Your Dealer for Service.
By the way correct me if this issue is not here for being from Isuzu or tell me how to open another post thanks