Chevrolet Corsa Alzavidrios Problem

Please I need help
when I go out in the morning in my vehicle, the rings-vidries normally work in the four doors without any problem. But after about 20 or 30 minutes when the engine already grabs temperature, they do not work for me, and remain like this all day. Then when the afternoon and the temperature of the day arrives at low, I get into the car and connect again, but after a while when the vehicle grabs temperature again they stop working. I think that it may be affecting heat in all this, since I realize that it only works when the vehicle is cold in the morning when I leave and at night, because throughout the day, with the heat it makes here, they do not work. I have reviewed the driver's side button and the corresponding fuse but everything is in order. I know there is current, since it works in the morning and night, but as I said, when it already grabs temperature or is hot they disconnect. I think that some connector with the heat is released and disconnected, but I have already reviewed the connector of the button control and is fine. Such is a wiring problem, I don't really know . I know it is a strange problem, but if someone can help me I would appreciate it very much.

Good day brother places a good land to the chassis since that car has a problem with consumption and the cable

Thanks friend was that .. Check the connection to the chassis and of course I was dirty and did not grab well
thanks for your help